Basic functions
6
Logamatic 4321/4322 - Technical specifications are subject to change without prior notice.
22
6.4
Set the room temperature
With the flap closed you can adjust the room temperature with the dial. With the
flap open, also press "Day mode" or "Night mode".
With the dial, you can select the room temperature in degree steps between
52 °F (11 °C) (day), or 36 °F (2 °C) (night), and 86 °F (30 °C). The set
temperature is displayed via an LED next to the dial. For temperatures below
59 °F (15 °C) or above 77 °F (25 °C), the "–" or "+" LED illuminates.
The factory setting for the day room temperature is 70 °F (21 °C).
The factory setting for the night room temperature is 63 °F (17 °C).
Any adjustment applies to all heating zones allocated to the MEC2 remote
control (
Æ
Chapter 7.7).
6.4.1 For the current operating mode
You are currently in automatic "Day mode" and would like to change the room
temperature.
(Condition: For this, the user interface flap must be closed.)
Turn the dial to the desired day room temperature (here: "73°F" (23°C)).
The day room temperature is now adjusted to 73 °F (23 °C). The selected
permanent display will then appear again.
AUT
USER NOTE
The set room temperature applies to the currently active heating mode, i.e. day
or night mode. You can identify which heating mode is ON depending on which
green LED is lit up.
room temp set
automatic day
73°F
Summary of Contents for Logamatic 4321
Page 80: ......
