btsr SMART CLEARER, Operating Manual

Page: 21 / 81

Operation
SMART CLEARER -3.9 -
Other factors that may affect the control
DELAY CONTROL
Is the sensor waiting time before starting the control process, namely the time
needed to the machine to reach the set speed
(Programmable as 1 to 250 seconds).
LOCK/UNLOCK
It defines the Touch Light button operating mode:
LOCK:
The button is enabled for the Automatic Numbering procedure only.
UNLOCK:
The button is enabled not only for the Automatic Numbering
procedure, but also for reset in case of alarm.
MONITOR-CONTROL
It defines the operating mode of the system when a defect is detected:
MONITOR:
Signals the error by means of a single flash of the red Led, without
activating the Stop output.
CONTROL:
Activates the Stop output and signals the error by means of a
variable sequence of the red Led:
1 red flash
= NEP
2 red flashes = SLUB -
3 red flashes = SLUB
4 red flashes = YARN-
5 red flashes = YARN+
8 red flashes = Yarn not running in the correct
position or non homogeneous
dirtiness accumulation
permanently lit = NOYARN
STOP C/P
It defines the operating mode of the STOP output to meet the application needs:
STOP C:
The signal is configured as Continuous (C)
STOP P:
The signal is configured as Pulse (P) (2 sec.)
STOP NO-NC
It defines the operating mode of the Stop output:
STOP NO:
The Stop output is normally open and it is connected to ground to
signal an alarm condition.
STOP NC:
The Stop output is normally closed (connected to ground) and it is
opened to signal an alarm condition.