BTL - 09
user manual & user's guide
page 3 of 42
I. USER
MANUAL
CONTROLS AND DISPLAYS
1. Output connectors to connect applicators.
2. Push-button to change mode ("Program" – "Frequency").
3. Two push-buttons to set program or frequency.
4. Displays set mode, number of program or frequency.
5. Push-button to change channels.
6. Control lights to signal channel in use.
7. Push buttons to set time in "Program" mode or time and frequency change (wave swing) in „Frequency„ mode.
8. Displays time or frequency change. Two control lights below signal mode in use.
9. Push-button to switch to „Frequency„ mode.
10. Two push buttons for intensity of magnetic field.
11. Push-button to start and interrupt therapy.
12. Displays intensity of magnetic field. Intensity is shown in mT if one applicator is used, and in % if adapter plug is
used (signaled by LED diodes under the display). Also displays code of applicator when an applicator is
connected to the instrument.
13. Push-button to set parameters of the last therapy.
14. Column bar-graph to display output.
15. Control lights to signal output failure.
OUTWARD APPEARANCE
BTL-09 is built in a lacquered metal box. Signals, displays, controls and connectors for applicators or adapter plug are
located on the front panel. The mains connector, power switch, fuses and cooling ventilator are located on rear panel.
Serial number, model number, and date of production are also located on the rear panel.
PRINCIPLES OF SAFETY OPERATION
1. Read carefully user manual before initial switching-on.
2. Check the parameters of mains (230V / 50Hz).
3. Check proper installation of electrical mains.
4. Place the instrument on an even hard board to assure its proper cooling.
5. Do not use the unit if the cooling fan does not start working after the instrument is switched on.
6. NEVER use damaged applicators. Electrical current damage to persons may be caused.
7. Stop the therapy at once in case of any failure.
8. Check all parameters before you start the therapy.
9. Attending personnel should keep in 1 meter distance from the applicators in use. Relevant channel should be
switched off during necessary manipulation.
10. Watches, electronic devices and magnetic recording carriers can be damaged when exposed closely to
applicators and cables.