Verve 500 – Issue 2 – Edition 2 – 19.10.06 – 7878
If you experience any problems, please call the Helpline on 0870 242 6652 or email [email protected]
Phone does not work
•
Have you installed the battery pack correctly? See page 7-8.
•
Check that the mains power is correctly connected.
No dial tone
•
Is the telephone cord of the base plugged into the phone socket?
•
Check that the mains power is correctly connected.
•
Only use the telephone cord supplied with the phone.
Cannot dial out or receive calls
•
Check that the mains power is correctly connected.
•
The battery may need recharging.
•
Has there been a power cut? If so, place the handset back on the base for 10 seconds and try
again. If it still does not work disconnect the batteries and mains power for 10 minutes, then
reconnect and try again.
You have a dial tone, but the phone will not dial out
•
You may need to change the dial mode from tone to pulse.
•
If you are connected to a switchboard, check whether you need to dial an access code.
Handset does not ring
•
The ringer volume may be switched off, see page 29.
•
Check that the mains power is correctly connected.
•
Make sure the handset is registered to the base, see page 33.
74
Help
