Diverse 3010 Executive – Edition 4 – 22 November ’00 - 3509
7
Place the handset on the base.
When charging, the battery level
symbol shown on the display flashes.
4
Fit the handset belt clip
Fit the belt clip onto the back of the
handset.
5
Charge the handset
batteries
When charging for the first
time, we recommend that
you let the batteries charge
for the full 16 hours before
making and receiving calls.
Battery performance
After charging your Diverse 3010
Executive for the first time, subsequent
charging time for the handset batteries
is approximately 4-5 hours. Batteries
and case may become warm during
charging. This is normal.
Battery display when inserting
or replacing a battery
When you replace the handset batteries
with ones that have been fully charged,
the battery indicator will not show full
until the next charge cycle has been
completed. Charge the handset until
the batteries register full again. From
then on the display will be correct.
Tab
Slot
SETTING
UP
Slide battery cover down and lift off.
3
Install the rechargeable
batteries in the handset
The handset uses the two AA size
rechargeable batteries, which are
supplied. You must only use approved
batteries. To install them, insert the
batteries as indicated on the inside of the
battery compartment or in the picture
below. Slide the battery compartment
cover shut. The battery compartment
cover may be found in the packaging
with the batteries.
Diverse 3010 Executive 22/3/01 12:02 pm Page 7