Description
2
CLS Pro 600 – Line and Contrast Sensor
9/108
The
CLS Pro 600
line and contrast sensor is an integral part of our
BST-eltromat web guiding systems. You are only allowed to use
BST-eltromat web guiding systems to correct the position of web-
shaped materials (e.g. those made from paper, film, cardboard,
rubber, etc.). The sensor and the control panel must never in be
installed and used in potentially explosive areas.
BST-eltromat web guiding systems have been designed and built
in accordance with state-of-the-art standards and the recognized
safety regulations.
Nevertheless, its use may constitute a risk to life and limb of the
user or of third parties or damage the BST-eltromat web guiding
systems and other equipment. Therefore BST-eltromat web guid-
ing systems are only to be used if they are working correctly and
in a technically safe condition. Any part found to be working incor-
rectly must be replaced immediately. Only original spare parts are
to be used for this. Spare parts obtained from third parties cannot
be guaranteed to comply with the design and manufacturing con-
ditions and safety regulations. In this case any guarantee claims
made against the BST-eltromat web guiding system will be invalid-
ated. Only qualified personnel who have been trained on the sys-
tem are allowed to undertake any work required on the BST-eltro-
mat web guiding system (i.e. installation, commissioning, opera-
tion, maintenance, etc.). Intended use also includes adhering to
the instructions given in this operating manual. Use for any pur-
pose other than those mentioned above is considered as contrary
to the intended use.
BST eltromat International GmbH
does not
accept liability for any damage resulting from this type of use.
2.3
System Description
2.3.1
System Design
General Information
The
CLS Pro 600
consists of the sensor and the removable control
panel.
The sensor enclosure holds the entire electronics and the control
panel and controller connections.
Sensor with Fitted Control Panel
The sensor is operated via the control panel, which is fitted to the
sensor in the factory. The control panel is pivotable.
