Operation
6
CLS Pro 600 – Line and Contrast Sensor
51/108
6.4
Operation
6.4.1
General Information
DANGER
Danger of cuts!
Never touch the edges of moving material webs! You are only al-
lowed to run setup when the production machine is stopped.
The guiding mode is determined and an automatic equalization to
the characteristics of the material that has to be scanned is run
during the setup.
6.4.2
Activating Line Setup / Edge Setup
Use the setup keys to select the type of setup (line or edge) that
you want to use.
NOTICE
Caution!
Setup can only be run when the controller is in MAN or SC mode.
6.5
Standard Operation
Certain settings, i.e. the so-called jobs, have been set up in the
main menu for the current applications (e.g. slitter, etc.). All of the
necessary basic settings will be implemented when the required
job is selected. You only have to enter the necessary set-up (edge
or line) for the work. The system is now ready for operation.
6.5.1
Selecting a Job
Jobs are loaded via the
\\parameter\jobs\choose job\load job
menu.
The following selection window will be displayed. You can select
between the jobs entered in the factory here.
Job Name
Meaning / Function
DEFAULT
Resets the default factory settings
COLORED
LINE
These settings are used when a coloured line has
to be tracked and it lies in a field with changing
conditions.
SMALL LINES
This setting must be used if lines with a width of
less than 0.5 mm have to be scanned.
STRICT
CHECK
Select this setting if very constant measuring and
printing conditions are present, regardless of
whether there is a lot of noise present in the field.
In this case the system will block it relatively
quickly, but the danger of latching on to contrast
