6
Operation
52/108
CLS Pro 600 – Line and Contrast Sensor
Job Name
Meaning / Function
caused by noise is minimal. Use, for example, if
there are large breaks in the line (ratio between
the broken and usable signal > 20%).
VERY TOLER-
ANT
Select this setting if extremely poor measuring
conditions are present (uneven web running,
changing print quality, etc.) but no noise spikes.
The number of blocking actions undertaken will be
kept to a minimum in this case. Use, for example,
when the color of the edge being scanned changes
frequently or if the print in alignment mode is un-
even.
If you are unable to enter any of these settings for your applica-
tion you can use the relevant settings to create your own jobs.
The procedure is described in Section 6.6.2.
If you have changed over to setup mode or if the set-up line or
set-up edge keys are pressed again in setup mode, then the cur-
rently loaded job ① will be displayed on the screen for 2
seconds.
If it is not displayed, then the system will be operated using the
machine default values or manual modified parameters, which
have not been assigned to a job.
6.5.2
Edge Setup Mode
1. Use the
arrow keys
① to select
MAN mode
.
2. The selected mode will be displayed with a green border
around it. Confirm the selection by pressing
ENTER
. The current
mode will be displayed in the top right of the screen ③.
3. Press key
SETUP EDGE
②
The LED inside the
SETUP key
will illuminate. The LED inside
the
ENTER key
will flash. The sensor light will be switched on
and it will flash. The laser is switched on and the laser line ④
will be visible simultaneously.
