bSeen X E-bike, Owner'S Manual

Page: 12 / 26

INSTALLATION - CONNECTIONS OVERLOOK
Once all LED units and handlebar switch cables are in place, these will
need to be connected to the ECU.
The Handlebar Control Unit cable has a fixed Higo connector at the end,
and the connection is made directly onto the ECU.
The LED units’ cables are supplied with 2 metres length, and these, if you
wish, can be cut to size (read “attention” box below) .
Each LED unit cable is marked with a red sleeve, which indicates the LED’s
positive polarity.
ATTENTION
If you wish to cut any LED cable to size, make sure you mark the positive
polarity prior to the cut.
Inverting polarities won’t damage neither the LED unit, nor the ECU unit.
The result will be a non blinking LED unit, and the connection to the
ECU will need to be re-done.
6 pin Higo connector
LED unit’s positive core
LED unit’s negative core
+ -