BRUNSWICK INSTALLATION MANUAL
PAGE 13
APOLLO
ATTACHING RAIL CLOTH
(CONTINUED)
FIGURE SIX
Step #7:
Staple three places along the rear edge of the
pocket facing X, then trim off excess cloth at pocket area.
Step #8:
If rail is an end rail, repeat Step 7 at other
corner pocket. Then, starting at center of rails, stretch
cloth tightly over cushion and staple at bottom of rail
working toward each end.
FIGURE SIX
FIGURE SEVEN
Step #9:
Trim excess cloth from bottom of rail flush
with edge of cloth relief groove.
FIGURE SEVEN
SIDE POCKET
FIGURE EIGHT
Step #10:
At side pocket, stretch the cloth tightly over
nose of cushion and staple three places as shown.
FIGURE EIGHT
FIGURE NINE
Step #11:
Slit the cloth up to the edge of cushion nose
as shown. Then firmly pull the small strip to the rear of
the cushion and staple at rear of facing.
FIGURE NINE
FIGURE TEN
Step #12:
Hold the small fold in place with thumb and
forefinger and firmly hold it down over facing. Then
staple at rear of facing and at bottom of rail as shown.
Step #13:
Trim excess cloth as required.
FIGURE TEN
