PAGE 12
BRUNSWICK INSTALLATION MANUAL
APOLLO
ATTACHING RAIL CLOTH
CORNER POCKET
FIGURE ONE
Step #1:
Place cloth on rail with the back side down.
The cloth should have equal amount of overhang at both
ends of rail and extend 1/2" over the featherstrip groove
on the cushion side as shown.
Step #2:
Except for approximately 3" at end of rail, tap
featherstrip down with a tapping block and hammer,
starting at center of rail. Stretch cloth tightly toward
each end of rail and tap featherstrip down.
FIGURE ONE
FIGURE TWO
Step#3:
At each end of rail, pull the cloth toward the
rubber cushion an additional 3/4". Then tap remainder of
featherstrip down.
FIGURE TWO
FIGURE THREE
Step #4:
Trim the cloth on cushion side of featherstrip
along the total length of featherstrip as illustrated.
FIGURE THREE
FIGURE FOUR
Step #5:
Fold the cloth down over front of rail, then
using thumb and forefinger as a guide along front edge
of the cushion to keep the tapping block at rear edge of
featherstrip, tap the featherstrip down flush with rail
surface as shown.
NOTE:
Never try to tap a featherstrip flush with just a
hammer as you will surely dent the rail surface behind the
featherstrip.
FIGURE FOUR
FIGURE FIVE
Step #6:
Turn rail over and at corner pockets fold the
cloth over the mitred edge as shown, stretching tightly
and working out any wrinkles as you staple three places
in area shown.
FIGURE FIVE
