31
©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-1550 02-09-2009
CHANGING CONTROLS FROM RIGHT TO LEFT ARMREST
1. Remove the switch housing weldment
by removing the Torx head machine
screw under the arm. The trim hold-
ing the harness on the backside of the
arm slides off.
2. To disconnect the harness under the
seat, remove the seat hinge nut.
3. Slide the harness cable guide off.
4. Reinstall the seat hinge nut.
5. Remove the 2 screws from the swivel
switch cover, then remove the cover.
(continued on next page)
As shipped from the factory, the Electra-
Ride
TM
II is set up for left-side installation
(
as viewed from the bottom of the
stairs
).
To convert the elevator for right-side
installation:
1. Make sure the circuit breaker switch on
the rear of the carriage is in the OFF
position.
2. Remove the left side carriage cover
(the cover without the speed control).
3. Set the No. 3 DIP Switch on the
4-ganged dip switch to the
ON
position.
The circuit breaker must be
turned OFF while changing
from left-hand to right-hand
installation.
Otherwise, the board will not
accept the change.
CONVERSION TO RIGHT-HAND INSTALLATION
4-ganged DIP switch
• switch 1 = diagnostic
• switch 2 = diagnostic
• switch 3 = right-hand install
• switch 4 = coast delay
LEARN switch
