11
©2009,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-1550 02-09-2009
1. Assemble the rail joint by attaching the
bottom plate to the rail with the screws,
lock washers and hex nuts provided
with the unit.
2. Install the bolts, internal-tooth washers
and hex nuts through the joint blocks
on both sides of the rail.
3. Tighten all bolts securely and make
sure screw heads are flush with the
surface of the inside of the rail.
NOTE
The chamfered edges of the
holes must face "up" toward
the bottom of the rail.
NOTE
Always install the rail
with the gear rack
towards the center
of the stairs and the
gear teeth facing wall.
Once two sections of
rail are installed, and
before installing the
carriage, run a plomb
line along the rail. If
the rail bows, insert
shims or readjust
clamps.
INSTALLATION
RAIL JOINT ASSEMBLY-Residential and Commercial Units
