© 2015 Brunner GmbH
Assembly instructions Support frame for suspended fireplaces (1.0)
19
11. Mounting and leveling of
firetable supports
1.2 = Support adjusting screw
2.2 = Firetable support beam
4 = M12x80 bolt
5 = M12 nut
6 = Supporting bracket
7 = M14x30 screw
Illustr. 32: Mounting parts of firetable
support
Working steps:
Remove the adjustable feet from the fireplace
front on the left and right. This is where the sup-
porting brackets (
with screws (7).
Push the firetable support beams into the mount-
ing slots of the support frame. The rectangular
beam in front should be positioned close to the
fireplace, but remember to leave at least a 3mm
gap between them. If the gap is too wide, cut
the supporting beams on both sides to the same
length. Use the adjusting screws (
1.2) to set in level.
After the horizontal position is set, tighten the
bolts 4 (see picture: Detail S and picture: 'Mount-
ing parts of firetable support') up to the support-
ing bracket 6 and secure with nuts 5.
Illustr. 33: Detail of
)
