Bruker Gilson, Installation Manual

Page: 22 / 30

22
Z31545_00_006
Software
Figure 4.12: The Terminal Program Text Field
When using the function key READ 1 second either the correct barcode information or a
’BR’ (bad read) will be displayed in the text field after 1 second.
If the barcode reader is not working correctly you can check the version and settings by
pressing the
Check Connected button. This will display this information in the text field.
For service personnel only: The version information (see Figure 4.12: ) is used for
service recommendations. With old barcodes (until DA04) or new barcodes (from
DA05), different initialization strings should be sent.
4.3 HyStar Software Setup
When using the HyStar software with barcode reader support, the barcode reader must
be first setup in the HyStar software before use. The procedure for doing this is
described in the next section.
Start the HyStar program and open the Hardware Setup window.
Version Information