Page 38 of 42
© Brüel & Kjær Vibro
● C107758.002 / V04
Technical alterations reserved!
EN
UNRESTRICTED DOCUMENT
10
Maintenance
NOTE!
Maintenance and service work must only be performed by trained qualified personnel!
VCM-3 does not require any regular service or maintenance. It contains no moving parts. Input
calibration has been done at the factory and no further calibration is needed. For recalibration please
contact Brüel & Kjær Vibro or your local sales representative.
In case of defects on the VCM-3, replace the VCM-3 and return the defect unit to factory for repair.
When cleaning the device on the outside, only use a damp cloth.
Be careful not to expose the inside of the device to humidity, i.e. from water or other liquids.
11
Disposal of product
VCM-3 is subject to the EU Waste Management Legislation for electrical and electronic devices.
Do not discard the device in the household waste and observe the local regulations for disposal of
waste or return the device to Brüel & Kjær Vibro
– Leydheckerstrasse 10 – 64293 Darmstadt –
Germany. WEEE-Reg.-No DE 69572330.
