BRP I-Command Evinrude Etec Series, User Manual

Page: 90 / 113

88
Evinrude E-TEC Engine Warnings
The I-Command gauges monitor engine conditions and display warnings in the event of a malfunction. The
following table lists warnings that are specific to Evinrude E-TEC models. Refer to the outboard Operator’s
Guide if any engine warnings are displayed.
WARNING MESSAGE DISPLAYED POSSIBLE CAUSE / PROCEDURE
Sensor malfunction see dealer
Throttle position sensor fault detected
Analog 5V supply overload detected
Exhaust pressure circuit fault detected
RPM reductn activated see dealer
System Voltage below expected range
System Voltage above expected range
Winterization Mode activated Auto-winterization routine activated
Overheat RPM reductn activated see manual EMM temperature above expected range
Low battery voltage see manual Battery voltage below expected range
Overheat Eng Shutdwn see manual
Engine shutdown, EMM above max temperature
Engine shutdown, engine above max temperature
No Oil Shutdwn see manual Engine shutdown, excessive no oil fault
No Oil RPM reductn check oil Oil solenoid open circuit
Water in Fuel, service soon Water in fuel detected