BRP Can-Am OUTLANDER 400 EFI 2014, Operator'S Manual

Page: 111 / 164

MAINTENANCE PROCEDURES
NOTE: The XPS oil is specially formu-
lated and tested for the severe require-
ments of this engine.
If not available, use 4-stroke SAE en-
gine oil that meets or exceeds the re-
quirements for API service classifica-
tion SM, SL or SJ. Always check the
API service label certification on the oil
container it must contain at least one
of the above standards. Refer to the
viscosity chart for details.
Engine Oil Viscosity Chart
SAE 0W30
SAE 5W30
SAE 10W30
10W40
SAE 15W40
SAE 20W50
Temperature Range
50°C (122°F)
40°C (104°F)
30°C (86°F)
20°C (68°F)
10°C (50°F)
0°C (32°F)
-10°C (14°F)
-20°C (-4°F)
-30°C (-22°F)
Engine Oil Change
Oil and filter are to be replaced at the
same time. Oil change should be done
with a warm engine.
CAUTION The engine oil can
be very hot. In order to avoid poten-
tial burns, do not remove the engine
drain plug or the filter cover if the
engine is hot. Wait until engine oil is
warm.
Ensure vehicle is on a level surface.
Remove dipstick.
NOTICE
Pay attention not to lose
the O-ring on dipstick.
1
V07C0 L A
2
RH SIDE OF ENGINE
1. Dipstick
2. O-ring
Clean the oil drain plug area.
Place a drain pan under the oil drain
plug area.
Unscrew oil drain plug.
vmo2008-019-023_a
RH SIDE OF ENGINE
1. Oil drain plug
2. Gasket ring
Allow oil to drain completely from
crankcase.
Change gasket ring on oil drain plug.
Clean gasket ring area on engine and oil
drain plug then reinstall plug.
______________
109