BRP Can-Am Defender 2022 Series, Operator'S Manual, Page: 140 / 240

138
16. Refill as necessary.
17. Ensure oil filter and drain plug
areas are not leaking.
18. Dispose oil and filter as per your
local environmental regulations.
O Oiill F Fiilltte err
M Mo on no o C Cyylliin nd de err E En ng giin ne ess
R Re em mo ovviin ng g tth he e O Oiill F Fiilltte err
1. Clean oil filter area.
2. Remove the oil filter cover and the
O-ring.
1. Oil filter screw
2. Oil filter cover
3. O-ring
4. Oil filter
3. Remove and discard oil filter.
IIn nsstta alllliin ng g tth he e O Oiill F Fiilltte err
1. Check and clean the oil filter inlet
and outlet area for dirt and other
contaminations.
1. Inlet bore from the oil pump to the oil filter
2. Outlet bore to the engine oil providing
system
2. Wet a NEW O-ring with engine oil
and slip onto oil filter cover.
3. Install the new filter into the cover.
4. Apply engine oil to the seal on the
open end of the oil filter.
1. Slightly oil
2. Slightly oil
N NO OT TIIC CE E
P Pa ayy a atttte en nttiio on n tto o a avvo oiid d p piin ncch hiin ng g
tth he e O O--rriin ng g d du urriin ng g ffiilltte err a an nd d cco ovve err
iin nsstta alllla attiio on n..
5. Install the cover on the oil filter
housing.
6. Tighten oil filter cover screws to
specification.
T Tiig gh htte en niin ng g T To orrq qu ue e
Oil filter cover
screws
10 ± 1 Nm
(89 ± 9 lbf-in)
7. Wipe off any oil spillage on engine.
T Tw wiin n C Cyylliin nd de errss E En ng giin ne ess
R Re em mo ovviin ng g tth he e O Oiill F Fiilltte err
1. Remove the engine service cover.
2. Clean oil filter area.
MAINTENANCE PROCEDURES