Brown Products Trench Master 459-001, Owner'S And Operator'S Manual

Page: 15 / 34

ROTORS FOR BROWN REDEFINER R450H/HA
AND THE WIREMASTER MOLE R460HA
The REDEFINER (Models R450H & HA) is designed to redefine existing beds. The
rotor which is standard on the R450 will dig a trench 3” deep with a 4” angled width.
If a 4” depth is desired, reposition the front wheel to the top position. The depth of
the trench is determined by the position of the front wheel. There are 3 positons (2”,
3”, 4”). The bottom position will dig 2” deep, the middle positon (standard setting
from the factory) will dig 3” deep and the top positon will dig 4” deep. The spoil dirt
from the trench is dispersed widely into the bed which minimizes having to spread
the dirt with a rake.
The following rotors will fit on the Redefiner and will dig a trench as indicated below.
The drawback of using a trenching rotor on the Redefine is that the machine is de-
signed to disperse the dirt into the bed so there is no dirt available to cover the
trench.
Rotor #450-100 3” Redefining Rotor (3” deep x 4” wide) The total length from tip
to tip is 13” inches. Rotor #460-002 (3” deep x ¾” wide) will fit on the Redefiner but
will not leave dirt piled to fill the trench.
The WIREMASTER MOLE (Model R460HA) is designed to install invisible dog/pet
fence and wire for remote devices/mowers at a depth of 3” to 4”, depending on the
front wheel setting. The R460HA is shipped from the factory with Rotor #460-002 in-
stalled at the standard front wheel position (middle position) which will dig a trench
3” deep and 3/4” wide (total length, tip to tip is 13”). If the desired depth is 4” deep,
reposition the front wheel to the top position. The Wiremaster Mole will dig a trench,
install the wire and refill the trench, all in one operation/pass.
ROTOR NUT REMOVAL
Turn Left
to Remove
Turn Right
to Tighten