2
FCC Compliance
Federal Communications Commission (FCC) Declaration of Conformity (For USA Only)
Responsible Party:
Brother International Corp.
100 Somerset Corporate Blvd.
Bridgewater, NJ 08807-0911
USA
TEL: (908) 704-1700
declares that the product:
Product Name:
Brother Stamp Creation System
“Stampcreator Pro”
Model Number:
SC-2000USB
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures.
To correct interference
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• The enclosed interface cable should be used in order to ensure compliance with the limits for a Class B digital device.
• Changes or modifications not expressly approved by Brother Industries, Ltd. could void the user’s authority to operate the equipment.
General Precautions
• Be sure the machine is always placed on a level, stable surface.
• Keep the machine and its accessories out of direct sunlight and extremely dusty places. Dust and dirt can cause distortion to the stamp image.
• Do not expose the machine, or any of its accessories, to extreme temperatures or high humidity.
• Do not try to disassemble the machine or any of its accessories.
• When connecting and disconnecting the cables, always be sure to grab the connectors, not the cords.
• Store the draft sheets, ID labels, and cleaning sheets in their packages.
• Do not use folded or damaged draft sheets, ID labels, or cleaning sheets.
• Do not look directly at the flash from the xenon lamp unit.
• Be careful that the CD ROM is not scratched.
• Do not put heavy objects on the CD ROM.
• Do not touch the printed draft sheet before creating a stamp.
• Do not remove the clear protective film before engraving a stamp.
• Do not reuse the ink pad as ink will have permeated the pad surface.
• Do not stand the stamp upside down immediately after it is assembled.
• Do not place the stamp on its side immediately after it is assembled.
• Do not touch the print heads.
• Do not use cleaning devices other than the print head cleaning pen and cleaning sheets supplied with the
Stampcreator Pro.
• Only lift the machine by grabbing the specified areas.
• Make sure that the power requirements specified for this machine are met.
• Do not touch the machine’s internal parts since they can become extremely hot after the machine has been used for a long
period of time.
• To prevent dust from entering the machine, do not leave the machine for a long period of time with the ink ribbon
compartment cover or stamp compartment cover open or the xenon lamp unit or draft sheet magazine tray uninstalled.
• Do not touch any of the machine’s internal sensors.
Summary of Contents for Stampcreator PRO SC2000USB
Page 62: ......
