10. STANDARD ADJUSTMENTS
47
KE-434C,435C
10-15. Moving stitch patterns
•
Programs which have already been programmed can be moved up, down and to the left and right.
* Once the power switch has been turned off, the amount of movement that has been stored in memory is reset. However, if
memory switch memo-28 is set to ON, you can keep the amount of movement recorded in memory. (The amount of movement
is retained in memory even when the power switch is turned off.)
* The amount of movement is reset when you change the program number.
•
The feed position can be set to the any position desired.
1. Select the program number, and then press the start switch once to move the feed mechanism to the sewing start position.
2. Press the SELECT switch (1) until the PROGRAM NO. indicator (2) illuminates.
3. While pressing the TEST switch (3), press the RESET switch (4).
* The TEST indicator (5) will illuminate and <
> will appear in the display window (6).
4. Press the SELECT switch (1) so that either the X-SCALE indicator (7) or Y-SCALE indicator (8) illuminates.
5. Press the DISPLAY SET switches (9) to move the feed mechanism one pulse at a time.
•
If the DISPLAY SET ( ) switch is pressed while the X-SCALE indicator is illuminated, the feed mechanism will move to the
left.
•
If the DISPLAY SET ( ) switch is pressed while the X-SCALE indicator is illuminated, the feed mechanism will move to the
right.
•
If the DISPLAY SET ( ) switch is pressed while the Y-SCALE indicator is illuminated, the feed mechanism will move down.
•
If the DISPLAY SET ( ) switch is pressed while the Y-SCALE indicator is illuminated, the feed mechanism will move up.
6. When the TEST switch (3) is pressed after the above fine adjustments have been made, the TEST indicator (5) and display
window (6) will both switch off and movement of the stitch pattern will be completed.
Note:
When moving the stitch pattern, take the whole of the pattern area into consideration so that no parts extend outside the sewing
area when the pattern is sewn.
* If you would like to set the feed position to a desired position, carry out steps 2. to 6. above while the display window (6) is
flashing. The stitch pattern will not be moved at this time.
2583Q
