Brother BES-1241BC, Instruction Manual

Page: 102 / 182

BES-941BC • BES-1241BC
100
Chapter 5 Setting
Setting of Mending
Details of mending can be set in case of a thread breakage.
Contents of each setting item are as described below.
Item Contents
For setting a mending end point (number of stitches before a thread
breakage) within the range of 1 ~ 10.
This function is previously set to 1 stitches upon shipments.
For setting whether to reset a thread breakage error automatically
This function is previously set to (Manual) upon shipments.
For resetting an error automatically
For resetting an error manually
For setting whether to stop embroidering temporarily at the mending end point
For stopping embroidering at the mending end point
For stopping embroidering temporarily at the mending end point
and then starting all heads automatically
For not stopping embroidering at the mending end point and
continuing embroidering
Manually trim the lower thread immediately after resetting a
thread breakage error if feeding by stitch back is long (i.e., 40 to
50 mm or more) in this mode.
Set the thread trimming method to
.
For setting a thread trimming method using the immediately after
resetting a thread breakage error. (This setting is effective only once
after resetting the error.)
For trimming both upper and lower threads
For trimming the lower thread only
For not trimming any thread
Refer to "Mending" ( Page 127).
1. Press .
2. Select by pressing .
3. Press .