Brother BES-1241BC, Instruction Manual

Page: 37 / 182

Chapter 1 Preparation of Embroidery Machine
BES-941BC • BES-1241BC
35
BES-1241BC
4. Pass the thread through the hole of the upper thread guide (U), wind it into the tension disk
clockwise once, and place it on the spring.
5. Pass the thread through each hole of the upper thread guide (U) and the thread guide (C).
6. After passing the thread through the hole of the thread guide (U), insert the thread into the
right side of the inner thread guide, and pass it through the hole of the thread take-up.
7. Bring the thread to the inner thread guide again to insert it into the hole from the upper
section, then into the lower thread guide.
8. Pass the thread through the hole of the needle bar thread guide, then pass it through the
needle eye, without passing it through the presser foot.
1. Pass the upper thread from the cotton stand through the hole of the thread guide right above
each cotton stand bar from the lower side.
2. Pass the thread through the upper hole of the pretension. Push up the tension disc with your
finger, and place the thread under the disc. Then, pass it through the lower hole.
4
3
2
1
5
6
7
8
No.2,5,8,11
No.1,4,7,10
Needle Bar No.3,6,9,12