68
Chapter 11
Remote Control Commands
Follow the commands below to access features remotely. When you call the fax machine and enter
your Remote Access Code (1 5 9
), the system will signal you with two short beeps to enter a
remote control command.
Remote control commands
Detail Operation
91 Playing voice messages
After one long beep, the machine plays ICM.
1 Skip back
Press
1
while listening to an ICM to play it again. If you press
1
before a message, you will hear the previous message.
2 Skip next
While playing ICM, you can skip to next message.
9 STOP Playing
Stop playing the ICM.
93 Erase all ICM
If you hear one long beep, the erase is accepted. If you hear
three short beeps, you cannot erase because all voice
messages have not been played, or there is no voice message
to erase.
*This code erases all recorded messages, not one at a time.
94 Play and Record OGM in
memory
1 Play
1 TAD MSG
The machine plays the selected OGM. You can stop playing
OGMs by pressing
9
.
2 F/T MSG
3 PAGING MSG
2 Record 1 TAD MSG
After one long beep, you can record the selected OGM. You
will hear the message played once. You can stop recording
the message by pressing
9
.
2 F/T MSG
3 PAGING MSG
95 Changing Fax
Forwarding/Paging setting
If you hear one long beep, the change is accepted. If you hear
three short beeps, you cannot change it because the
conditions have not been met (Example: registering paging
number).
You can register your fax forwarding number by using
4.FAX FWD NO. (See
, page 71.) Once you have registered the number, the
machine will automatically turn to “FAX FWD:ON” mode.
Then retrieve a Memory Status List by entering
9
6
1
to make
sure that the Fax Forwarding number you registered is correct
in the List.
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD NO.
Summary of Contents for 1030e
Page 1: ...FAX 1020e FAX 1030e USER S GUIDE ...
Page 107: ......
