25
X-VA-MT3809G-MT3810G-eng/541B182AAG/A/2022-10
Brooks Instrument
Installation Manual MT3809G & MT3810G
Section 2 Installation
How to Remove and Reinstall GP Housing Indicator Covers
Directions to remove and reinstall the GP Housing
&RYHUDQGDGMXVWWKH3RLQWHU
7REHJLQPDNHVXUHWKHÀRDWLVDWUHVWDQGWKHUHLVQ¶W
ÀRZJRLQJWKURXJKWKHPHWHU
2. Loosen the 4 cover screws.
- For aluminum housing, use a T20 TORX drive tool.
- For stainless steel housing, use a #2 Phillips drive tool.
Note, the screws will stay attached to the cover.
3. Remove the cover from the housing. The gasket should
still be attached to the cover in the gasket groove. If not,
place the gasket into the groove of the cover.
8VLQJDÀDWEODGHVFUHZGULYHUZLWKDEODGHKROGWKH
pointer and turn the screw to align with the “R” on the scale.
It may take a few adjustments to get the pointer on the “R”.
5. To replace the cover, place the cover against the housing
and tighten the 4 screws using the same tool used in step
2. Tighten to 45 in-lbs or 5.08 N-m to keep a watertight seal.
and tighten the 4 screws using a T20 TORX tool. Tighten to
45 in-lbs or 5.08 N-m to keep a watertight seal.
