AMETEK Brookfield Page 39
Manual No. M09-1200-F1016
Details on the information that can be viewed under each tab follows:
a) Raw Data:
All test types display the specific fields chosen for the raw data graph.
Figure IV-14: Raw Data Graph for Flow Function Test
b) Stress Data:
All applicable Peak and Steady State stresses are shown. In addition, the following is
displayed for each type of test:
• Flow Function Test data shows a locus line for each Consolidation Stress setpoint,
with corresponding Unconfined and Over Consolidated Mohr circles, and a Steady
State locus line. For the Steady State locus, the gradient, angle, and cohesion are
reported. For each Consolidation Failure Locus, the Major Principal Consolidation
Stress, Unconfined Failure Strength, Angle of Internal Friction, gradient, angle,
cohesion, and density are reported.
• Time Consolidated Flow Function Test data shows all the instantaneous locus lines
and circles, plus a time consolidated locus line for each Consolidation Stress setpoint
with its corresponding Unconfined Mohr circle. All instantaneous flow results are
reported; each time consolidated locus reports its Unconfined Failure Strength and
cohesion.
• Wall Friction Test shows one locus line for each Displacement setpoint and one
Maximum Wall locus, including the gradient, angle, and cohesion for each locus
line.
• Density Test data: Not applicable.
