WARNING!
IMPORTANT INSTALLATION INSTRUCTIONS
IMPROPER INSTALLATION CAN LEAD TO SEVERE INJURY OR
DEATH
READ AND FOLLOW ALL INSTRUCTIONS
•
Commercial/Industrial Sliding Door Operator
shall be installed more than 8’ above the floor
•
Install only on a properly operating and balanced door within the rated values for door weight, door width and
operating forces as stated on the ratings label
•
Do not connect door operator to source of power until instructed to do so
•
This door operator shall be installed and serviced by a qualified technician, electrician or electrical maintenance
person familiar with its operation and the potential hazards involved.
•
Any person performing installation or service on this product shall read this manual first. Proper installation includes
following all steps outlined in the
Installation Instructions
and the settings specified under the
Parameters
section.
•
Assure all electrical wiring and grounding is installed as specified in this manual and as required by any local codes.
Proper installation can also reduce the risk of electrical shock, fire or explosion.
•
Locate activation switches or push button stations: (a) within sight of the door, (b) at a minimum height of 5’ so small
children cannot reach and (c) away from moving parts of the door.
•
Install the Entrapment Warning Placard next to the activation switches in a prominent location
•
As described in this manual, the Stop command controlled by the motor drive is not intended to be a fail safe or
Emergency Stop (E-Stop) since it does not prevent the motor drive from malfunctioning. This can only be
accomplished by disconnecting the AC power to the operator (terminals L1 and N).
•
This door operator is to be a permanent or “hard” wired connection to the supply voltage. The electrical contractor
shall install a dedicated breaker or line switch to disconnect each ungrounded pole of the door operator from the
supply voltage. Each ungrounded pole shall have a minimum of 3mm contact separation.
•
If this model is equipped with a manual release, disengage pin(s) between door and door operator before manually
moving the door.
