31
Cleaning and / or replacement of glass
For the cleaning of the glass the security screw (central upper side of the door) will be unscrew with the key provided with the insert.
IMPORTANT!: please, take care when unscrew the screw because the door may suddenly fall and the glass could be broken. Hold the door
until it is balanced! (
see drawing D23
).
D23
2.2.2
MODELS LONDRES-V, LONDRES-T AND LONDRES-T VISIÓN
The models Londres-T and Londres-T Visión include a turbine with the same characteristics than the model Volga. The model Londres-V has
not this turbine.
Everything referred in the points before is also applied to models Londres-T and Londres-T Visión.
Also it is obligated consider the next:
Heat exchanger (only model Londres-V)
The heat exchanger that cross the hood of the insert must not be blocked, it is necessary
to leave the holes open in order to achieve a better ventilation of the insert, increasing its
performance. (
see drawing D24
).
Replacement of the electrical components (only models Londres-T and Londres-T Visión)
It is compulsory to leave an access in the central low part of the masonry or facing to the repair
/ replacement of the turbine in case of breakdown. This register may be a grille with minimal
measures 400x200mm (wide x high).
Electrical connection (only models Londres-T and Londres-T Visión)
Disconnect from power before any electrical handling.
Then, we will connect the temperature sensor which is provided with the switchboard to the insert
according the attached drawing.
Placement of optional frames
The standard frame included with models
Londres-V, Londres-T and Londres-T Visión are
removable. To place an optional frame (M-8,
M-9, etc.) it is necessary to remove the standard
frame and then replace the optional one with the
same grills. To remove the standard frame it is
necessary unscrew the 4 screws of the frame (2
in each side). Then, place and screw again the
new frame (
see drawing D25
).
WARNING!! If the insert is installed
and covered and you want to buy
another new one optional frame
it is important to advice of this to
your distributor when you are going to ask
for it.
2.2.3
MODEL EVEREST
Some models include on the top an oven with an hermetic oven chamber. The base
of the oven is made of refractory brick (it absorbs heat and irradiates it). Heating
is produced when the smoke passes through the sides and the upper part of the
oven. On the roof of the oven there is one pipe that connects the cooking chamber
with the smoke outlet in order to remove the gas generated in the oven.
The oven has the following components:
-
Thermometer
It is disassembled and you can find it in the baking
tray. It shows the cooking temperature of the oven. To install it, it is
necessary to introduce the sheath through the hole of the door and,
then, put the nut (
see drawing D26
).
D25
Probe placement
D24
D26
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
INSERTS
EN
Summary of Contents for BRISTOL
Page 103: ...102 ...
