6
Connecting the Hot Water Supply
PRODUCT INSTALLATION
1.
Connect the hot water supply.
a. Locate the hot water supply line in your bathroom
under your sink/washbasin and turn the water supply
valve all the way off.
b. Drain the hot water line by turning the sink tap on
the hot setting until no more water comes out.
c. Disconnect hot water supply hose to sink from shut
off valve. You may have to use a 3/8" compatible
wrench or a similar tool (not supplied).
2.
Install the Hot Water 3/8" T-Valve and the Small Rubber
Washers as needed onto the hot water shut off valve
under the sink.
3.
Reconnect hot water supply line to open end (top)
of T-valve.
4.
If it hasn’t been removed already, unscrew the Pressure
Cap covering the Pressure Connector on the T-valve.
a. Slide the pressure cap over the open end of the of
Hot Water Flex Tubing with the inside threads facing
towards the open end.
b. Push the hot water flex tubing over the pressure
connector.
c. Slide the pressure cap down until the cap meets the
pressure connector. Screw the cap onto the T-valve
until secure and tight.
Step 1c
Steps 2-3
Step 4a
Step 4b
Step 4c
CAUTION:
Do not over-tighten the pressure cap. You will risk
damaging the tubing.
IMPORTANT:
Be sure to slide the hot water flex tubing over the
pressure connector until the tubing slides past the
“lip” of the pressure connector and it cannot go
any further.
NOTE:
There may be some residual water in the hose, use a
small container or towel to catch any residual water.
Summary of Contents for FreshSpa Comfort+ FSR-15
Page 47: ... 20FSR15 0227 ...
