brondell FreshSpa Comfort+ FSR-15, Owner'S Manual, Page: 10 / 47

8
NOTE:
If there is any leaking, check all rubber washers and make sure all water connections are
tight and secure. If necessary, you can use plumbers tape for any leaking connections.
TIP:
If spray direction is off-center after installation, unscrew the bolts, reposition the
attachment slightly forward, and secure back in place. Depending on your preferences
or body composition, the perfect position may require some readjustment.
4. Connect hot water tube to bidet attachment
(for dual temperature only).
a. Take the hot water tubing pressure connector
and remove the pressure cap.
b. Slide the pressure cap over the open end
of the of hot water flex tubing with the inside
threads facing towards the open end.
c. Push the pressure connector into the open
end of the of hot water flex tubing with the
washer facing out.
d. Hold the pressure connector up against the
hot water inlet on the bidet attachment. Slide
the pressure cap along the tubing and screw
the cap onto the hot water inlet until the
pressure connector is secure.
5. Turn on water supply & check for leaks.
a. Open the main water supply valve slowly
and check for leaks.
b. Wait 5-10 minutes, check again, and if there
are no leaks, continue.
Installation
PRODUCT INSTALLATION
IMPORTANT:
Be sure to slide the hot water flex tubing over
the pressure connector until the tubing slides
past the “lip” of the pressure connector and it
cannot go any further.
Step 4d
Step 4b
Step 4c