15
OPERATION
Using the Swash
Important note:
The wash functions and the warm air dryer function will not work
unless the body sensor in the seat detects someone sitting down (skin conductivity
sensor). To override the safety sensor, please refer to the section in the manual called
“Configuring a Special Mode”.
Important note:
The remote control will not operate the Swash if the batteries are weak,
dead, or not installed properly (remote requires 3 x AAA batteries to function).
Warm Water Wash
Sit on the seat and press the FRONT or REAR button on the remote to begin water flow.
The nozzles will self-clean and purge a small amount of water which will last for several
seconds prior to starting the wash function. The front or rear wand will then extend and
wash for approximately 1 minute, then turn off automatically.
To keep the wash continuing longer than 1 minute, press the FRONT or REAR button
again during the cleansing cycle. Each time your press the button during the cleansing
cycle the 1 minute cycle starts again.
If you would like to stop the wash before a 1 minute cycle ends, press STOP button to
discontinue flow.
While cleansing, users can adjust the water temperature, water pressure, spray width,
and nozzle position according to their preferences.
After the cleansing cycle, the nozzles will perform a self clean cycle purging water for
approximately 5 seconds.
** You cannot increase the water pressure level higher than level 2 under the following
conditions: Main water supply temperature is under 50 degrees F / 10 degrees C OR if
the rated power source is under 110V.**
Nozzle Positioning
While the cleansing function is operating, use the Nozzle Position up and down arrows
on the remote control to move the position of the nozzles and spray.
