10
a.
Install the T-Valve with the rubber washer to the incoming water
connection on the bottom of your toilet tank. Be sure that you place
the flat edge of the rubber washer into the T-Valve against the metal
with the raised lip facing the toilet tank connection.
b.
Connect the water supply line coming from the wall to the bottom
of the T-Valve.
4.
Connect Bidet Hose to T-Valve
a. Connect one end of the bidet hose to the T-Valve and set aside.
5.
Install Mounting Plate & Attach Swash
a.
Place adjustable mounting plate over mounting holes on toilet,
flat side down, black rubber side of mounting plate should be
closest to the toilet tank and rubber should be against the ceramic.
b.
Place adjustable metal brackets flat side down in the center of the
square opening in the mounting plate and insert mounting bolts
through adjustable metal brackets and mounting holes. Be sure
that the square mounting bolt head is even with sides of adjustable
metal bracket.
c.
Slide rubber cone washer, flat washer, and then barrel nut onto
mounting bolts under the toilet bowl and tighten to keep mounting
plate in place.
d.
Set the Swash flat on the toilet bowl in front of the mounting
plate, and slide seat onto plate until it is secure and “clicks”
into place.
e.
If the seat appears too short or too long for the toilet, adjust the mounting plate
accordingly. To adjust the mounting plate, loosen barrel nut and slide seat forward or
backwards as needed. Once the seat is lined up properly, tighten barrel nuts to hold
in place.
6.
Connect the Bidet Hose
a.
Connect the bidet hose to the side of the bidet seat making
sure the hose is firmly connected. Take care not to twist the bidet
hose, excessively bend it, or strip the plastic screw threads
when screwing the hose onto the bidet seat.
7.
Turn On Water Supply
a.
Open the main water supply valve slowly and check for leaks.
b.
Wait 5 minutes, check again and if there are no leaks continue.
INSTALLATION
Step 5d
Step 6
Steps 5b & 5c
Steps 3a & 3b
