S T E P O N E -
C O N N E C T I N G T H E W AT E R S U P P LY:
1. Shut off water supply.
2. Cut out an adequate opening in the wall according to the dimensions of the cable sleeve,
the water supply pipe and the mounting base, where you want to install the spout.
3. Cut two small holes for the mounting base support and drive the anchors in.
4. Remove the outlet and trim ring from the mounting base, by removing the securing grub
screw from the underside of the outlet.
5. Mount the mounting base with the support through the opening, and secure the base
support to the two holes using two screws.
Important: The mounting base should be installed so that the outside surface of the finished
wall falls between the min and max lines marked on the base.
6. Connect the water supply pipe from outlet side of the solenoid body to the inlet
connection on the mounting base.
7. Pull the wires of the power supply and solenoid out of the mounting base.
8. Feed the wires through the cable sleeve
9. Connect the electronic unit’s connections coming out from the mounting base to the
solenoid and power supply connectors.
10. Fit the trim ring and outlet to the mounting base on the wall. Secure the unit with the grub
screw to the underside of the outlet.
O U T L E T A N D S E N S O R I N S TA L L AT I O N G U I D E
F O R 2 . 2 7 0 6 . 9 4
15
16
Summary of Contents for 2.2702.90
Page 13: ...I CSEN 210509...
