Brocade Communications Systems Brocade TurboIron 24 Series, Hardware Installation Manual, Page: 18 / 78

18 Brocade TurboIron 24X Series Hardware Installation Guide
Part Number: 53-1003053-03
Product Overview
Hardware features
Figure 4 shows the front panel of the AC power supplies used in the TurboIron 24X (at the rear of the device).
FIGURE 4 AC power supply front panel
The power supplies are auto-sensing and auto-switching, and provide up to 300 watts of total output power, having a universal input (90
VAC to 264 VAC) and 12 VDC regulated output.
Power supplies can be swapped in or out of the device while the device is running, and without opening the device. You can remove one
of the supplies without interrupting operation because the remaining power supply provides enough power for all of the ports.
For power supply hardware specifications, refer to “Power supply specifications” on page 55.
Disconnect the power supply cable from the power source (outlet) before you install it in or remove it from
the device. Failure to do this can result in damage to the power supply or the device, or both (the device
can be running while a power supply is being installed or removed, but the power supply itself should not
be connected to a power source).
The TurboIron 24X power supply is designed exclusively for use with TurboIron 24X. Installing the power
supply in a device other than a TurboIron 24X will cause extensive damage to your equipment.
1 AC LED
1