Brocade Communications Systems Brocade TurboIron 24 Series, Hardware Installation Manual, Page: 61 / 78

Brocade TurboIron 24X Series Hardware Installation Guide 61
Part Number: 53-1003053-03
Hardware Specifications
Power supply specifications
For power cord specifications, refer to “Input connector and plug” on page 62.
Power supply specifications
This section contains the following information for the power supplies that ship with TurboIron 24X devices.
•
“Overview”
•
“Key features”
•
“Physical dimensions and weight”
•
“Environmental considerations”
•
“Power supply consumption”
•
“Input connector and plug”
•
“Regulatory compliance”
•
“Safety warnings”
•
“Electrical specifications”
Overview
Each TurboIron 24X switch comes with two alternating-current (AC) power supplies. The following power supplies may be installed in
your TurboIron 24X switch:
•
RPS-TI24X (AC power supply)
The power supplies can be swapped in or out of the device while the device is running, without opening the device. You can remove one
of the power supplies without interrupting operation. The remaining power supply provides enough power for all the ports.
Remove the power cord from a power supply before you install it in or remove it from the device.
Otherwise, the power supply or the device could be damaged. The device can be running while a power
supply is being installed or removed, but the power supply itself should not be connected to a power
source.
All power supplies are auto-sensing and auto-switching.
Key features
Refer to “Power supplies” on page 17 for the key features of the TurboIron 24X power supplies.
Physical dimensions and weight
TABLE 8 Physical dimensions and weight of power supplies
Power Supply Dimensions Weight
AC 4.06 cm (1.6 in.) (H) x 10.67 cm
(4.2 in.) (W) x 22.86 cm (9 in.) (D) (2.84 lbs)
1.29 kg