Broaster 2400XP, Operation Manual

Page: 49 / 52

12–7
FILTERING TIPS
COMPLAINT CAUSE REMEDY
Motor will not start
Turn cook/
filter switch
to OFF position to avoid
splashing of oil when motor
protector reset button is
pushed.
1. Overload tripped
2. Cook/filter switch OFF
3. Open or faulty wall fuse or
circuit breaker
1. Wait for overload to cool.
Push red motor protector
reset button located on
rear of motor.
2. Turn to FILTER.
3. Check wall fuse or circuit
breaker.
Motor hums but will not
start
1. Solidified shortening in
pump
2. Crumbs in pump
1. Turn cook/filter switch
OFF. Contact service per-
son.
2. Turn cook/filter switch
OFF. Contact service per-
son.
Motor starts but will not
pump
1. Filter pan not completely
installed
2. O-ring on riser line not
installed
3. Solidified shortening in
piping or filter pan
1. Firmly push filter pan in.
2. See FILTERING.
3. Turn cook/filter switch
OFF. Contact service per-
son.
Motor starts but will not
pump or stops at any level
1. Filter paper or hold down
improperly installed
2. Not using enough
Broaster
®
filtering com-
pound
1. See “Cooking Oil Care
and Filtering” on page 8-
1.
2. Next filtering cycle,
ensure proper amount of
Broaster
®
filtering com-
pound is used.
Motor starts but stops
pumping when oil is level
with top of hold down,
approximately 1 inch of oil
in bottom 1. Filter paper improperly
installed or crumbs under
filter paper or hold down 1. See “Cooking Oil Care
and Filtering” on page 8-
1.
broaster.com Manual #16285 8/05 Rev: 2/14