Broadrack KSR-11508-DVI, User Manual

Page: 34 / 41

KSR Series User Manual
28
3.4 Turning on the Console
Make sure all cables and the power cord are connected properly. Be sure to tighten all
connector screws. Grab the front handle. Pull the console all the way out then lift the
panel up. This will disengage the momentary on / off switch and the unit should
power on. The LED on the left of the panel will be green light.
3.5 Testing the Console
To test that the console is working properly, perform the following steps:
1. Power up the console, and then turn on your computer.
2. Make sure the video image is centered within the screen area. Use the OSD
controls to adjust the image (see note below) or press the Auto button on the left
or underneath of the panel.
If the unit does not power on when the panel is pulled up, try to push
the power on / off button on the left of the LCD panel to power up the
unit.
You can adjust the horizontal and vertical position, contrast, and
brightness to better suit your video card and your personal preference.
Refer to Chapter 2 for more information on using the on-screen menu
to adjust the video display.
Before you begin, make sure that powers to all the devices you will
be connecting up have been turned off. To prevent damage to your
installation due to ground potential difference, make sure that all
the devices on the installation are properly grounded. Consult your
direct vendor for any technical issues if necessary.