X7-4-Install-IG100 Installation Guide
Brocade
®
X7-4 Director Hardware Installation Guide
Time and Items Required
Allow approximately one hour to unpack and install the device in a rack.
The following tools are required when installing the 8U Airflow Diversion and Port Side Exhaust Kit for Four-Post Racks
(XBR-DCX4S-0121 and XBR-DCX-0130):
•
Torque wrench with No. 2 Phillips screwdriver tip
•
Flathead screwdriver
•
Hydraulic or assisted lift with a minimum raise of 140 cm (55 in.) and a minimum capacity of 113 kg (250 lbs).
Installing the Device in an 18–24-Inch Rack (XBR-DCX4S-0130)
Use the following instructions to install the device in a rack with a rail-to-rail depth of 45.72 to 60.96 cm (18 to 24
in.). Be sure to use the 18–24 in. 8U Chassis Airflow Diversion and Port Side Exhaust Kit for Four-Post Racks (XBR-
DCX4S-0130) for this installation.
Parts List
The following parts list refers to items illustrated in the following figure.
NOTE
Not all parts may be used with certain installations depending on the device type.
Table 7: Hardware for Airflow Diversion and Port-Side Exhaust Kit for 18-24 in. (45.72 to 60.96 cm) Racks
Description
Quantity
Top rail
1
Top rail mounting brackets for 18-20 in., (45.72–50.8 cm) 20–22-in. (50.8–55.88 cm), and 22-24.in
(55.88-60.96 cm) racks
3
Duct
1
Shelf
1
Shelf saddle
1
10-32 x .5 in. (1.27 cm) Phillips screw (blue Loctite on threads)
12
10-32 x .63 in.(1.60 cm) Phillips screw with square-cone washer
12
10-32 clip nut for racks that have rails with round holes
8
10-32 retainer nut for racks that have rails with square holes
8
Alignment washer for racks that have rails with square holes
12
6-32 x .25 in. (.635 cm) Phillips screw
2
X7-4-Install-IG100
29
Broadcom
Summary of Contents for Brocade X7-4 Director
Page 215: ......
