ACS5000 Installation Manual
Page 11
© 2017 Brivo Systems LLC. All rights reserved.
Rev 1
Follow safety precautions.
WARNING: Fire Code
NEVER CONNECT A KEYPAD/READER OR LOCK TO DOORS WITHOUT FIRST
CONSULTING THE APPLICABLE FIRE CODE.
You must consult with, and get
approval from, local fire officials before installing locks or devices on any
doors that may be fire exits. Use of egress push buttons may not be legal.
Single action exits may be required. Always obtain proper permits and
approvals in writing before installing equipment
WARNING: Fail Secure Mode
DO NOT INSTALL THE SYSTEM IN THE FAIL SECURE MODE UNLESS
PERMITTED BY THE LOCAL AUTHORITY HAVING JURISDICTION.
Doing so
may cause interference with the operation of panic hardware.
WARNING: Heat and Noise
DO NOT INSTALL THE CONTROL PANEL IN AN AREA THAT COULD DROP
BELOW 32 DEGRESS FAHRENHEIT OR EXCEED 120 DEGREES.
Doing so
can cause damage to components within the control panel.
DO NOT INSTALL THE CONTROL PANEL NEAR OR ON THE SAME CIRCUIT
WITH DEVICES THAT PRODUCE LARGE AMOUNTS OF ELECTRICAL NOISE.
This includes grinders, electric motors and blowers, electrical switch-gear
and other electrically noisy equipment. Electrical noise can interfere with
panel operation. If it is not possible to install the panel away from such
sources of noise, it is advisable to isolate it by using a high-quality UPS
(Uninterruptible Power Supply) between the AC Mains and the transformer.
•
Wiring methods should be in accordance with the National Electrical Code, ANSI/NFPA 70.
•
Category 5 cabling is the minimum performance category recommended.
•
If powered by 12VDC, the power supply must be a UL294 listed power supply.
