18
6.5 Quick Start Guide
Once all parameters have been set:
1. At the Master Controller press the “M” button until
“Heating”
is displayed at the bottom of the screen
2. Press the
On/Off
button to call for heating
3. Increase the temperature set point to above room
temperature for
Zone A
only
4. Confirm
Zone A
is operating as intended
5. Repeat independently for the remaining zones
6. Turn on all zones to confirm system operation
7. Turn the unit off once Heating setup is confirmed
8. Press the
“M”
button until
“Cooling”
is displayed at the
bottom of the screen
9. Press the
On/Off
button to call for cooling
10. Decrease the temperature set point to below room
temperature for
Zone A
only
11. Confirm
Zone A
is operating as intended
12. Repeat independently for the remaining zones
13. Turn on all zones to confirm system operation
14. Turn the unit off once Cooling setup is confirmed
7.0 SYSTEM HAND OVER
1.
Set the time and day
2.
System operation
3.
Product and warranty registration
4.
Service notification
5.
ZonePlus commissioning information
7.1 Setting the Time & Day
This is to be done at the Master Networker which displays the
word
“Clock”
opposite Key
“5”
or the
Clock
Key
.
•
Press the
On/Off
button to turn the System OFF.
•
Press Key 5,
Clock
Key
, and the screen will display the message
"Clock setting mode", and then the Digital Clock will flash
•
Use the
Rotary
Dial
to select the correct time.
•
To set the day, press Key 1, the
Day
Key
until the correct day of
the week appears on the left of the screen, e.g. "Mon".
•
Press Key 5 the
Clock
Key
again to save your new settings
Zone Cycle
Note
:
If multiple Brivis NC-6 Controllers are installed, only the
Master Controller has the ability to set the clock time and day.
The Master control can be identified by the word
"Clock"
beside
Key “5”
, when the ZonePlus system is in the OFF position.
Summary of Contents for ZonePlus B061006
Page 35: ...32 Notes ...
