30
Note
:
•
A flashing snowman symbol indicates that the compressor within the air-conditioner appliance is yet to switch ON
•
A flashing FAN symbol indicates that the fan is yet to switch ON
General Operating Symbols
•
The thermometer on the display registers the current room temperature with the small marker beside it indicating
the temperature that the heating/cooling system is currently set to maintain
•
The bar adjacent to the Key 1 button is displayed when continuous fan operation has been enabled using the Key
1 button
Note:
•
The actual room temperature appears in the top right of the display screen
•
“continuous” fan operation results in the fan being switched on all the time to allow continuous circulation of air
1.5 Operating the Fan Only
To simply circulate the air in the house, the fan can be made to run continuously.
With the Networker switched OFF press the Fan button (Key 1 button). After a small delay a rotating fan symbol will appear
and air should begin circulating within the ductwork of your system.
To switch the fan OFF simply press the Fan button (Key 1 button).
1.6 Coded Messages
While the Networker is operating your system, it is also monitoring and controlling every aspect of the system’s
performance.
If anything unusual occurs, the Networker will display a message stating “Air-Conditioner Fault – R01 Code#??” for
assistance call the number across the top of the screen. There are two parts to the message: the R01 number designates
which appliance has the fault, and the “Code#??” relates to the type of fault. The screen will also display the spanner
symbol.
Whenever such a message appears, it is a good idea to write it down before doing anything else.
This code contains information that will enable Brivis to deal quickly and easily with anything that requires their attention.
With many of them you will be asked to contact Brivis Service and pass on the message, the model and type of appliance.
Message repeating
Push the Function button followed by the Key 1 button quickly after to repeat a message.
Resetting
If something has interrupted the unit’s operation, the word Reset could appear beside the Key 4 button while a coded
message is scrolling across the top of the display. When this is the case the Key 4 button can be used to re-start the unit. If
the unit does not resume normal operation or the error message re-appears, contact Brivis Service.
