Britton 4Way, Instruction Manual

Page: 10 / 61

3. APPROVED SEAT BELT REQUIREMENT
WARNING: Your child car seat can only be installed forward facing using a three point lap and
diagonal belt in the front or rear passenger seats of the car.
4. INSTALLATION OF THE CARSEAT 9-18 KG (APPROX 9MONTH-4YEARS) GROUP 1
4.1 Adjusting backrest
Put the car seat on car seat facing forward and turn the turning knob (L) to make the backrest
touch closely the car seat (Fig. 5).
4.2 Routing the diagonal and lap belt
Make sure there is no twist of car belt. Route the diagonal belt through backrest belt hook (F)
and lap belt under armrest of seat base. Guide the metal tongue of car belt through the hole on
backrest on one side over the another side. Then put the diagonal belt above armrest through
diagonal belt guide (R) while lap belt under armrest (Fig. 6).
4.3 Tightening the child car seat
Check and make sure there is no twist of the belt. Insert the metal tongue of car belt into the
car seat buckle until you hear a clear „click“ (Fig. 7).
Tighten the seatbelt by pulling in the direction of the seatbelt reel (Fig. 8).
5. SECURING YOUR CHILD IN THE CAR SEAT FOR GROUP 1 (9-18KG).
5.1 Loosing the shoulder straps
Press the shoulder strap adjusting button (J) with one hand and simultaneously pull the shoul-
der straps (H) with another hand to loose it (Fig. 2).
5.2 Opening the buckle
Hold the two buckle latches with one hand, with another hand hold the main part of the buckle
pressing the red button with your thumb until two tongues pop out from the buckle (Fig. 9).
5.3 Seating your child in the car seat
Put your child in the seat and put the shoulder pads on the child’s shoulder (Fig. 10).
5.4 Locking the buckle
Guide the two buckle latches together and engage them into the harness buckle (E) (Fig. 11).
Warning! Make sure that two buckle latches are put together correctly and there is no twist of
the harness.
5.5 Tightening the harness straps
Pull the harness adjust strap (K) until the harness is a comfortable but FIRMLY around your
child. (Fig. 12).
Finally, pull both chest pads down from your child’s shoulders onto their chest.
Note: The chest pads are an important safety feature. Never use the child car seat without
them.
6. INSTALLING THE CHILD CAR SEAT (WITHOUT CHILD CAR SEAT HARNESS) 15-25KG
(APPROX 4-6 YEARS OLD) GROUP 2
6.1 Removing the harness system
Release the shoulder straps (H) and unhook it from the metal anchor (O) (Fig. 13).
Pull the shoulder pads (D) and shoulder straps (H) out of the strap slot out of the strap slot on
the shoulder strap height adjust board (M) (Fig. 14).
Get both buckle latches out from the shoulder straps (H). Now you can remove the shoulder
strap easily by pulling it from the seat base (Fig. 15).
Remove harness buckle (E) and crotch pad (I).
Raise the seat base cover (Fig. 16).
Slide the metal plate which is used to fasten the harness buckle to the seat shell down on its
edge through the strap slot (Fig. 17).
Take off the plastic plate on bottom of seat base (Q) (Fig. 17).
Slide the metal plate which is used to fasten the harness buckle to the seat shell up on its edge
through the strap slot (Fig. 19).