Instructions for Installation & Use - Series No. 8100/A/2013
Instructions for Installation & Use - Series No. 8100/A/2013
34
35
HOW TO SET-UP
HOW TO SET-UP
CONVERTING THE TODDLER
RESTRAINT INTO BOOSTER MODE
To use this child restraint as a booster seat the
harness needs to be stored under the cover.
Disengage and remove the seat belt from the
restraint.
You will need to remove the upper anchorage strap
from the anchor fitting when converting to a booster
seat.
Upper anchorage strap must always be used in the
booster position when re-installed.
If fitted, remove all comfort accessories from the
restraint.
CHILD USE WITH SLIDEGUARD™
CLIP
The SLIDEGUARD™ clip is found in a storage
recess under the cover, as shown below and is
connected to the buckle to form the SLIDEGUARD™
clip.
SLIDEGUARD™ clip
storage location
Place rolled-up Harness strap
and Harness Tongue in recess
STORING THE HARNESS
A. Disengage harness buckle. Fully lengthen the harness
by pressing the Harness Adjustment lever and pulling
the harness shoulder straps.
B. At the rear of the restraint, remove both harness
shoulder straps from metal Strap Connector by
slipping strap through open slot. The metal Strap
Connector is shown in diagram right.
C. Pull the shoulder straps through slots in the seat back.
D. Remove the Elastic loops holding the cover in place at
the lower front of the seat. Lift the cover to expose the
storage inserts in the seat base.
E. Feed the straps with harness tongues through the
bottom rear of the seat cover. Roll up each harness
strap with harness tongue and place into the left and
right rear recess in the seat base (underneath the
cover).
Strap Connector
A
B
E
Pull to
lengthen
Lift
CHILD USE
(BOOSTER SE
AT
MODE)
CHILD USE
(BOOSTER SE
AT
MODE)
