Instructions for Installation & Use
- Series No. BS4900A-020130
Instructions for Installation & Use
- Series No. BS4900A-020130
35
34
CHILD USE
(BOOSTER SE
AT
MODE WITH CHILD HARNE
SS
)
CHILD USE
(BOOSTER SE
AT
MODE WITH CHILD HARNE
SS
)
HOW TO INSTALL CHILD HARNESS
HOW TO INSTALL CHILD HARNESS
USING LAP ONLY SEAT BELT OR CONVERTED LAP-SASH
SEATBELT WITH THE CHILD HARNESS
Install the Child Harness to the booster seat and anchorages as detailed previously (page
28- 29). Install the booster seat into the vehicle. Ensure the top tether strap is attached to
the vehicle upper anchorage and adjusted correctly. With the vehicle seatbelt converted (if
necessary) ready for use, thread the lap seatbelt through the Child Harness strap loops as
shown.
NOTE: Seatbelt extenders should not be used
if the seatbelt is not long enough to fit around
the child. If a seatbelt extender is used then
the seatbelt buckle must not be in contact with
the child.
Use the child harness as detailed on page
26 - 27.
The shoulder straps must be in the slots
which are nearest to the child's shoulders, the
headrest should be adjusted to suit the child,
but shoulder straps should not be lower than
the child's shoulders.
Always adjust height of headrest and shoulder
straps as child grows.
SecureGuard™
Device
Child Harness
strap loops
1
Refer to child harness fitting instructions for further details.
Connect the Harness to the VERSATETHER™ Catch on the booster seat detailed on page 26
to 27.
A. With the child seated, place the Child Harness straps over each shoulder.
B. Feed the right hand strap (loop end) into the cross strap loop to connect the two sides.
C. Feed the adult belt (lap belt or converted lap/sash) through the harness strap loops,
ensuring that the cross strap loop does not disconnect. Ensure there are no twists in the
Child Harness, cross strap and seatbelt.
1. Vehicle Upper Anchorage Fitting
2. VERSATETHER™ Catch on Booster Seat
3. Child Harness Attachment Clip
4. Right Hand Harness Strap
5. Adjuster (under cover)
6. Harness Strap Loop
7. Cross Strap Loop
8. Cross Strap
Pull to remove
slack
4
5
7
8
6
6
2
3
USING THE CHILD HARNESS
:
DO NOT LEAVE CHILDREN UNATTENDED IN THE CAR.
Lap belt
