BRISTERS CHUCK WAGON, Operator'S Manual

Page: 12 / 68

Section 3 Assembly Instructions
Pre-Assembly Instructions
1) wner’s Manual .
nd assembly parts. Make sure you
ed on the previous page.
o have any questions or problems with your
Brister's Design & Manufacturing Co. LLC product
please call us,
66-646-5278.
Read O
2) Unpack all vehicle a
have everything list
3) If y u
toll free 1-8
Seat / Brushguard Assembly
1) Place seat back frame on vehicle frame tubes.
Insert a 5/16” x 2” socket head bolt through
both bottom joints. The head of the bolt should
be on the outside of the vehicle. Put a curved
washer on the threaded end of the bolt. Place
a 5/16” nylock nut on the bolts but
do not
tighten .
2) Place the cage on front vehicle frame tubes
and seat back. Insert a 5/16” x 2” socket head
bolt through all four joints. The head of the
bolt should be on the outside of the vehicle.
Put a curved washer on the threaded end of
the bolt. Place a 5/16” nylock nut on the bolts.
Tighten all 6 nuts (including step 3).
Bumper Installation
1) Align the holes in the front bumper with the
mounting holes in the front frame tubes. Insert
the four 5/16” x 2” bolts through the bumper
bracket and then into the frame tubes. Put a
curved washer on the threaded end of the bolt.
Place a 5/16” nylock nut on the bolts and
tighten.
Steering Wheel Installation
1) Remove the plastic steering column cover by
removing the 3 screws on the bottom with a
5/16” socket. If equipped with top and bottom
steering column covers
2) Turn vehicle steering so that it is pointed
straight forward. Line up holes in steering
wheel with mounting holes so that the center
spoke is pointing down. Install ¼” x 1 ¾” hex
head bolts from the back. Tighten with ¼”
nylock nuts.
3) Install steering cap with #8 black screw.
4) Re-install steering column cover.
12