© BriskHeat
®
Corporation. All rights reserved.
3
Full-Coverage Drum Heater
(FGDH & FGPDH Series)
IMPORTANT SAFETY INSTRUCTIONS
Agency Approvals
All FGDH and FGDH series marked with CE marking
Approvals valid only when
installed in accordance with
all applicable instructions, codes, and regulations.
DANGER
Do not immerse heater in liquid.
Keep enclosure cover tight while circuits are alive.
Use heater only in approved locations
Keep sharp metal objects away from heater.
Failure to observe these warnings may result in electric
shock, risk of fire, and personal injury.
WARNING
End-User Must Comply to the Following:
Only qualified personnel are allowed to connect
electrical wiring.
Disconnect all supply power at the source before
making any power connections.
All electrical wiring must follow local electrical
codes, it is highly recommended that NEC Article
427 is followed.
The person who performs the final installation /
wiring must be qualified for this work.
The end-user is responsible for providing a
suitable disconnecting device.
The end-user is responsible for providing suitable
electrical protection device. It is highly
recommended that a ground fault circuit breaker
is used.
Failure to observe these warnings may result in personal
injury or damage to the heater.
CAUTION
Never handle the heater while it is in operation;
Always disconnect the heater from the power
source and allow to cool prior to handling.
Inspect heater before use.
Do not wrap the heater over itself.
If spillage of foreign matter onto heater occurs,
disconnect from power source and clean after
heater is allowed to cool.
Never operate a heater without an appropriate
heat sink (device being heated is considered a
heat sink).
Fasten heater to device using approved methods
only.
Do not repair damaged or faulty heaters.
Do not crush or apply severe physical stress on
heater or cord assembly.
Disconnect heater when not in use.
Use specified sized heater with same sized drum.
Do not use for other applications.
Failure to observe these warnings may result in personal
injury or damage to the heater.
A person who has not read and
understood all operating
Instructions is not qualified to
operate this product.
DANGER
© BriskHeat
®
Corporation. All rights reserved.
4
Full-Coverage Drum Heater
(FGDH & FGPDH Series)
SPECIFICATIONS
Adjustable On / Off Digital Controller
50-450ºF (10-232ºC) for FGDH series
50-160ºF (10-71ºC) for FGPDH series
FGDH and FGPDH Series heated area:
55 & 30 Gallon - Heated area is lower two thirds
15 & 5 Gallon - Heated area is lower one third
Patented grounded heating element
Dielectric strength over 2000 volts
Power cord 6’ (2m) long
120 or 230 VAC Models
450ºF (232ºC) maximum exposure temperature on heating surface
Intended for use in dry environments. Do not expose to spray.
