6K689
Page 34
Mount cradle (210” and
270” models only) here.
Page 28
Row markers are mounted with mounting channels, as shown, with longer ones supported by arm cradles.
1. Place the mounting channels into position
and hold with 3/4” x 5 13/16” x 10 1/2” U-bolts
and lock nuts. Position them as far apart as
possible in accordance with row shank
spacing. Do not tighten firmly until you are sure
of final positioning.
2.
Using 3/4” x 6 13/16” x 5 3/4”
U-bolts, position arm cradles
in place at a point based
upon the extended length of
your row markers.
Be sure to check for possible
interferences before
mounting them permanantly.
[Note-Cradles are not required
on 150” frames.]
3. Next, using 3/4” x 6 13/16” x 7 5/8”
U-bolts and lock nuts, mount each
row marker.
Left hand marker
toward the rear of
the frame.
Be sure to mount each side
as shown with right hand
marker toward the front
of the frame.
4. Tighten all bolts.
Row Marker Kit
(Optional)
Mounting
Channel
U-bolts,
3/4” x 5 13/16” x 10 1/2”
Lock nuts, 3/4”
U-bolts,
3/4” x 6 13/16” x 7 5/8”
Lock nuts, 3/4”
U-bolts, 3/4” x 6 13/16” x 5 3/4”
Lock nuts, 3/4”
R.H.
L.H.
U-bolts,
3/4” x 6 13/16” x 7 5/8”
Lock nuts, 3/4”
U-bolts,
3/4” x 6 13/16” x 10 1/2”
Lock nuts, 3/4”
U-bolts,
3/4” x 6 13/16” x 10 1/2”
Lock nuts, 3/4”
U-bolts,
3/4” x 6 13/16” x 7 5/8”
Lock nuts, 3/4”
1200
rev3-10-03
(Note:On models built before Jan. ‘03,
check for possible interferences
between markers)
Front of
Machine
Figure 13
Figure 13a
Figure 14
