6K689
Page 20
Page 16
1200rev3-5-03
Page 16
1200
rev2-2-04
TO REPLACE SHANK MOUNT & LEG:
1. Remove shank leg from shank mounting.
2. Remove the three bolts that secure the
spring pivot plates to the shank mount.
3.
Loosen pivot plates spacer bolt if necessary
to rotate spring assembly upward so assembly
rests over front spring bracket.
4. Remove shank mount pivot bolt and discard
shank mount.
AUTO-RESET SHANK IS ALWAYS UNDER LOAD
WARNING!
Spring is loaded and improper removal of bolts could result in serious
injury. Shank is spring loaded and serious injury could result as shank resets.
Do not disassemble without following procedure outlined in operator’s manual.
Do not use hands or feet to dislodge any obstruction holding the shank in the
tripped position.
5. Install new 8K365 shank mount by reversing
above instructions 4 through 2.
6. Insert plug assembly in shank mount.
7. Install shank leg using bolts, washers and
nuts as shown in Figure 8b-1 on previous
page.
8. Torque shank leg bolts to 400 ft. lbs.
(360-400 ft. lbs. is the min.-max.)
Shank Mount & Leg Replacement Procedure:
Figure 16
2
Remove the 3
bolts that secure
the spring pivot
plates to the shank
mount.
6
Insert plug assembly
in shank mount.
5
Install new 8K365
shank mount --
Torque value for 3/4” lock
nut is 155-210 ft.-lbs.
