Brillion Field Commander HFC16, Operator'S Manual, Assembly Instructions, Page: 62 / 64

2K314
SPECIFICATIONS
(Subject to change for product improvement)
Model Designation
The basic model designations are:
“HFC” - “HFCT” - “HFK” - “HFKT”
The numbers following the letters indicates the machine width in feet between the centers of
the two outermost shanks on the machine.
Basic Machine Specifications
Operating depth range 0 to 5 inches
Shank clearance 26 inches from bottom of frame to sweep tip
Road clearance 9 to 14 inches (varies with operating depth)
Shank trip height 13 1/4 inches
Shank trip force 142 pounds
Shank spacing 6 inch center to center, no shanks closer than 24” on
any tooth bar
Front to rear spacing 30 inch on rear bar, 32 inch all others
Sweeps 1J808, 7 inch wide 47 degree shank angle--check
clearances if using wider shanks
Points 2J605, 2 inch wide reversible point
Shank Material 9/16 x 1 3/4 alloy steel
Pivot Greaseable, hardened bushing
Main frame & wings 5 bars of 3” x 4” tubing
Overall length 21 feet
Maximum Transport heights HFC 23 & HFK 23 -- 10’ 5”
(optional spike harrows add HFC 27 & HFK 27 -- 12’ 5”
to transport height & width) HFC 31 & HFK 31 -- 14’ 5”
Transport width
HFC 16 to HFC 23 -- 13’ 10”
HFC 24 to HFC 31 -- 14’ 3”
Machine weights HFC 23 -- 5963# HFK 23 -- 5219# HFCT 23 -
6117# HFC 27 -- 6619#
HFK 27 -- 5739# HFCT 27 - 6833#
HFC 31 -- 7640# HFK 31 -- 6661# HFCT 31 -
7283#
Wheels & tires
Center section Walking tandem with (4) 9.5L-15 tires
Wings, 16 through 19 foot machines Single tires with (2) 6.70-15 or 7.60-15 tires
Wings, 20 through 27 foot machines Single tires with (2) 9.5L-15 tires; walking tandem
optional (use (4) 7.60-15 tires on tandems)
Wings, 28 through 31 foot machines Walking tandem with (4) 7.60-15 tires
Other features
Your BRILLION Field Cultivator is designed with a special linkage which keeps the machine level
throughout its operating and transport range. A link adjusts the tongue height to suit any tractor
drawbar height and serves to level the machine from front to rear. The drawbar hitch is a bal-
anced reversible yoke or bar type hitch made of heat treated ductile iron. The transport wheels
are controlled by a pair of master-slave cylinders which raise and lower the center section and the
wings evenly. In the operating position, the cylinders are completely retracted. Operating depth is
changed by adjusting the cylinder anchor adjust rods from a position in front of the machine.
194rev3-4-05 Page 48